Skip to content

Pad Installation & Removal (High Speed)


Step 1 Unplug Machine - Lock the machine handle in place and lay the machine down so the handle is resting on the floor and the bottom of the machine is at a 90-degree angle to the floor. Floor Buffer Pad Driver
Step 2 Remove centerpiece - Remove the centerpiece from the floor pad. This will leave a 3-inch hole in the middle of the pad. Pad Installation
Step 3 Installation - Align pad so that it is centered properly over the pad driver and turn center locking nut clockwise to attach pad to block. Continue turning so that center locking nut does not touch floor surface when burnisher is upright. Pad Removal
Step 4 Removal - Remove pad from block by turning center locking nut counter clockwise. Pad Removal