These 15 inch Jumbo steel wool floor pads are more absorbent, stronger, and more efficient at cleaning the grime off floors than synthetic floor pads. These pads fit on any of our 15" Low-Speed Floor Buffers. The fullness and springiness of these hand-wrapped pads allow them to quickly cut through grime without clogging. Since they are hand wrapped, there are no welds, wire stays, or stitches that could possibly scratch your floors.
These Jumbo pads are perfect for cleaning, dry scrubbing, polishing, or finishing almost any type of floor at the toughest angles. They can even be shaken out to be used over and over again. Once you cling the steel wool pad to the bottom of a fiber brush, the weight of the floor machine will keep the steel wool pad secure. If you are looking for more compact pad that is less prone to tear, shred, or fray, take a look at our 15 inch Textsteel pads.
You must select your desired grade from the drop-down menu above. We offer 8 different levels of abrasiveness for our steel wool floor pads. The grade is determined by the thickness of the steel wool wire. Please read the descriptions below to figure out which grade you need for your application.
#0000 (Finest): For buffing and cleaning. Buffs wood, shellac, lacquer, and varnish with wax or oil.
#000 (Extra-Fine): For buffing, polishing, and removing. Buffs new wax finishes and polishes stainless steel. Removes paint drips and splatters, as well as minor burns from wood and leather.
#00 (Fine): For buffing, cleaning, cutting, and removing. Buffs final finish on painted trim. Removes old finishes with finish remover.
#0 (Medium-Fine): For cleaning and removing. Good for use on marble floors. Removes rust from metal surfaces.
#1 (Medium): For cleaning and preparing. Good for use on granite flooring. Cleans linoleum, rubber asphalt, and other resilient floors. Prepares wood for the first coat of paint and smooths raised grain.
#2 (Medium-Coarse): For cleaning and removing. Good for use on VCT floors. Cleans glass or stone surfaces. Removes scuff marks and old wax from floors.
#3 (Coarse): For removing. Removes old paint and varnish.
#4 (Extra-Coarse): For removing. Removes the toughest rust, dirt, old paint and varnish. Not recommended for high gloss surfaces or delicate finishes.
Steel Wool vs. Sand Paper Comparison Chart
|Media||Coarse to Fine|
|Steel Wool (Grade)||#4||#3||#2||#1||#0||#00||#000||#0000|
|Sand Paper (Grit)||30-40||40-60||60-80||80-120||100-150||150-220||280-320||300-600|
|Internal Search Number||
126423 - 0
125704 - 1
127263 - 3
|Brand||International Steel Wool|
|Brush/Pad Diameter||15 inches|
|Quantity Per Carton||12|